Friday, 4 January 2019

Garage time

Driveline parts to install:


  • T50 TRD gear set OR W58 Supra gearbox
  • TRD 4.55 final drive
  • TRD LSD
  • Larger rear brake rotors

Engine

Normally aspirated induction:

  • RWD factory inlet manifold w/o TVIS plate
  • TRD injectors

Rebuilt ported cylinder head with:


  • TODA 304 high lift camshafts
  • TODA valve springs

Rebuilt bottom end with:


  • Carillo high compression pistons
  • Late model water pump (modified)
  • Manon racing products baffled sump
  • ARP head studs
  • ARP rod bolts



Friday, 4 March 2016

After trouble firing the fuel pump, I removed he wring loom, checked it all and added the required wires for the water methanol injection kit.
While I was at it I checked everything out and tifdied things up.
The loom is now returned to its rightful place.

Saturday, 16 August 2014

Dyno Time

Spent some time on the dyno at Autotech during the week.
After ironing out a couple of bugs, we got to the tuning.
Made a massive 12rwkW at about 3000rpm before we pulled the pin with air intake temps in excess of 100 degrees C, a problem I had expected.
Now going to water/methanol injection for charge cooling.

http://www.snowperformance.net/stage-2-boost-cooler.html


Monday, 4 August 2014

Wednesday, 9 July 2014

4AGE Motec Engine Maps


Graphs of fuel and ignition maps for the 4AGE n/a tune which I had carried out way back.

Fuel map - load by RPM

Ignition advance map - load by M

Engine Setup: 4AGE with HKS supercharger kit for AE86


















Toyota 4AGE
  • 7 rib block, but without oil squirters
  • 16 valve big port head
  • Balanced stainless steel crank
  • Low compression pistons from supercharged 4AGZEs
  • 375cc injectors from 4AGZEs
  • HKS 2mm metal head gasket for compression ratio 8.0:1
  • HKS adjustable cam gears
  • HKS 272 intake & exhaust camshafts
  • HKS supercharger kit
  • Techno Toy Tuning 145mm diameter crank pulley for approximately 15psi boost
  • HKS extractors
Motec M4
  • sequential injection
  • wideband lambda control
  • data logging
Fuel map - 4AGE with HKS Supercharger














Ignition timing map - 4AGE with HKS Supercharger







Tuesday, 8 July 2014

Exhaust

Custom exhaust just built by Powatone at Fyshwick, ACT.
Terrific looking job - 2.5 inch mandrel bent through a hotdog muffler, then 2 1/4 over the diff.
Great looking exhaust, but a terrible photo.

Better photos are available here.